Others have a “ carpet” or “ hard floors” setting. The right position depends on Shark vacuum models: If your Shark vacuum has a floor selector switch to activate the brush roll, check if it’s turned on in the right position. Shark Vacuum Roller Brush Not Spinning: Possible Reasons and Troubleshooting Tips Reason 1: Brush Roll Switch Not Turned On If not, I suggest contacting Shark company directly as there may be a problem with your specific model. Whether you own a Shark Rotator, DuoClean, Shark Apex, or Navigator LiftAway, this guide will surely be of help. However, to make things easier for you, I’ve done some research and listed all the possible issues and solutions. To be honest, I haven’t experienced all the possible reasons for this problem with my Shark Navigator since it may vary depending on Shark vacuums model. To fix this, make sure the battery is fully charged before inserting it into the vacuum. If it keeps turning off, it could possibly be because the battery has run out of juice. Note: you may need to repeat the cleaning process a couple of times for buttons that are heavily soiled.If you have a shark, you probably already encountered the “shark-vacuum-brush-not-spinning” issue.Īs a happy owner of a Shark Navigator Lift Away, I’m well aware of this problem.Īnd if you don’t have a second vacuum cleaner (no judgment here) on hand, you’ll need to get it fixed quickly. Battery Because a shark cordless does not require you to plug it to an outlet using wires, you need to constantly check on the battery. Let the buttons dry for at least 30 minutes before reattaching the battery and turning on the device. Repeat the process for all of the buttons that are sticking. Once you have cleaned one side, move your finger to the side of the button you just cleaned and clean the other side of the inside area of the casing that your finger was previously covering with the Q-tip.įinally, with some canned air, point the nozzle of the canned air parallel to the surface of the button and give it a few quick bursts of air to blow the debris out of the space between the button and the casing, but be careful to not blow any of the debris back into the device. #Shark duo clean vacuum lights flashing series#
Press down on one side of the button with your finger, while cleaning the inside area of the casing surrounding where the button is pressed in. IZ440 Series Shark Vertex DuoClean PowerFins Lightweight Cordless Stick Vacuum Troubleshooting Guide Shark Customer Service Official Support & Help Center. Now the inside where the button meets the casing needs to be cleaned with the Q-tip.
After cleaning with the Q-tip, push down on the button a few times to work out any grime that may have come out, and clean that off with the Q-tip as well. Use the Q-tip to clean the sides of the button that stick out from the casing, making sure to use the fibers of the Q-tip to clean as far into the sides as possible. You want the Q-tip to be saturated with alcohol but not dripping. Next dip the Q-tip into the isopropyl alcohol, making sure to shake off the excess alcohol.
Make sure the button and casework is facing upside down when you are cleaning it to prevent alcohol from dripping into the inside unit. Turn off the vacuum and remove the battery. You will need some Q-tips (or any cotton swabs), a bottle of high percentage isopropyl alcohol, and a canned air duster to clean the buttons. This article contains the Troubleshooting Guide for the IF280 Series Shark ION F80 Cord-Free MultiFLEX® Cordless Stick Vacuum.
0 kommentar(er)
